ALL MOTORWITCH BARS ARE CURRENTLY SHIPPING IN 4-8 WEEKS
FXR Division Motorwitch Handle Bars for Road Glide
FXR Division worked directly with one of the Industries top motor builders to design and Build a set of bars that would that give him and you the narrow width (30.5” from end to end with a 12 degree wrist angle which we have found the to be the closest to natural wrist position) and stance of a T bar, allow for a direct mount to your factory riser WITHOUT any need for expensive gauge and/or handlebar relocation plates, give FULL visibility of your gauges and media center, and hold up to the rigors of his performance riding abilities as well as his Built 151 Leading Edge performance equipped motor.
Like the Split MX, Split Angle, and G Series Bars… FXR Division manufactures these IN HOUSE out of 1.250 X .125 steel tubing, they make sure to debur ALL material inside and out prior to welding for the smoothest wire pulls, and like ALL of the FXR Division Bars, are Throttle By Wire READY!
Comes in Gloss Black Powder Coat.
For 2015 to 2020 Roadglide Models:
2021 and Later WILL REQUIRE an extend length Clutch Cable…
12” OR 14” Motorwitch Bars DO NOT Require extending cables and/or lines… Your Stock Cables work just fine!!!
Bars pictured on Black Road Glide are 14” FXR Division Motorwitch Bars, Bars pictured on the Red Road Glide are 12”… while we have had customers able to install WITHOUT extending cables… it may not always be the case.
If you would like to replace your OEM or extend your Clutch and ABS Brake Line… Parts RECOMMENDED and sold by FXR Division:
CAN BUS HANDLEBAR CONTROL WIRE EXTENSIONS
(1) GUERRILA CABLES Plug N Play CAN bus Xtra Length 34” (42” for 16 inch bars)
(1) Universal Clutch Line Adapter
(1) 70” Goodridge Clutch Line (71” for 16 inch Bars)
(1) Straight Banjo Fitting for Hydraulic Clutch Master Cylinder
TOP ABS BRAKE HOSE
(1) Goodridge ABS Adapter Block
(1) 60” Goodridge Brake Hose (63” for 16 inch Bars)
(1) Straight Banjo Fitting For Brake Master Cylinder
** If your OEM Perch Clamp has a locating pin… it will be necessary to remove it before installation**
*** Don't forget to get a set of NEW Gooden-Tite FLT Handlebar Bushings to go with your bars!***
****We normally DO NOT stock bars over 16”… they are Made To Order and may take a little bit longer to manufacture and ship… Orders for Bars over 16” WILL BE subject to a 20% Cancellation Fee if order is cancelled after 7 Days from the Date the Order was placed***
We do our BEST to have ALL of Our FXR Division bars In Stock. However, if you do not receive your tracking information within 1-3 Business Days… Then due to HIGH DEMAND, please allow 2-4 weeks for orders to ship.
ALL FXR DIVISION PARTS ARE PROUDLY MADE AND MANUFACTURED IN THE USA.